To adjust the CRT monitor alignment
Do not touch the CRT monitor sweep board. High voltages exist on the sweep board that
W A R N I N G
can cause personal injury.
Equipment Required
Equipment
Alignment Tool
Turn off the logic analyzer, then disconnect the power cord. Remove the cover.
1 1 1 1
Refer to chapter 6, "Replacing Assemblies," for instructions to remove the cover.
Connect the power cord, then turn on the logic analyzer.
2 2
Insert the disk containing the functional performance verification tests into the disk
3 3
drive, then load the functional performance verification operating system into the
logic analyzer.
4–6
Critical Specification
1
Recommended
Model/Part
8710-1300