To Inspect The Logic Analyzer - HP 1660C Series Service Manual

Preparing For Use
This chapter gives you instructions for preparing the logic analyzer for use.
Power Requirements
The logic analyzer power source requirements are either 115 V ac or 230 V ac, –22 %
to +10 %, single phase, 48 to 66 Hz, 200 Watts maximum power.
Operating Environment
The operating environment is listed in chapter 1. Note the noncondensing humidity
limitation listed below. Condensation within the instrument can cause poor
operation or malfunction. Provide protection against internal condensation.
The logic analyzer will operate at all specifications within the temperature and
humidity range given in chapter 1. However, reliability is enhanced when operating
the logic analyzer within the following ranges:
•
Temperature: +20 °C to +35 °C (+68 °F to +95 °F)
•
Humidity: 20% to 80% noncondensing
Storage
Store or ship the logic analyzer in environments within the following limits:
•
Temperature: -40 °C to + 75 °C (-40 °F to + 167 °F
•
Up to 90% at 65 °C
Humidity:
•
Altitude: Up to 15,300 meters (50,000 feet)
Protect the logic analyzer from temperature extremes which cause condensation on
the instrument.

To inspect the logic analyzer

Inspect the shipping container for damage.
1
If the shipping container or cushioning material is damaged, keep them until you have
checked the contents of the shipment and checked the instrument mechanically and
electrically.
Check the supplied accessories.
2
Accessories supplied with the logic analyzer are listed in "Accessories" in chapter 1.
Inspect the product for physical damage.
3
Check the logic analyzer and the supplied accessories for obvious physical or mechanical
defects. If you find any defects, contact your nearest Hewlett-Packard Sales Office.
Arrangements for repair or replacement are made, at Hewlett-Packard's option, without
waiting for a claim settlement.
2–2