Installing A Video Memory Upgrade - Compaq ProSignia 200 Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5. Install the heat sink retaining clip by attaching the end opposite from
the extended tab, then pressing down on the extension tab until the clip
snaps into place.
Figure 3-14. Installing the heat sink clip

Installing a Video Memory Upgrade

The ProSignia 200 has a Cirrus 5436 PCI performance graphics controller
integrated on the system board. The maximum memory upgrade is 1 megabyte
of EDO DRAM for a total of 2 megabytes of EDO DRAM.
To install the additional 1-megabyte EDO DRAM module on the system
board:
1. Shut down all programs and the operating system.
2. Turn off the server, disconnect the power cord from the electrical
outlet, and remove the side access panel.
Writer: Compaq Computer Corporation Project: Installing Hardware Options Comments:
CAUTION:
Static electricity can damage electronic components or
optional boards. Before beginning these procedures, be sure that you
are discharged of static electricity by briefly touching a grounded
metal object. Refer to Appendix C, "Electrostatic Discharge," for more
information.
File Name: E-ch3.doc Last Saved On: 4/14/97 11:21 AM
Compaq ProSignia 200 Server Reference Guide
3-15