Deleting The Password; Clearing The Password - Compaq ProSignia 200 Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6-6 Using Security Management

Deleting the Password

1. Turn on the server.
2. When the Power-On password entry screen appears, enter
current/
where current is the current password.
3. The password is now deleted until you establish a new password
through the System Configuration Utility.

Clearing the Password

If you forget your Power-On or Administrator Password, you can clear all
passwords by turning off the server and disabling the Power-On and
Administrator Password. You disable the passwords by moving the jumper at
E6 pin 5-6 to pins 6-7 on the system board. This jumper change does not take
effect until the server is turned on.
To clear the Power-On and Administrator Passwords, follow these steps:
1. Turn off the server.
2. Remove the side access panel of the unit.
3. Move the jumper at E6 pins 5-6 to pins 6-7 on the system board.
4. Replace the side access panel of the unit and turn on the server.
The feature is now operable.
NOTE : The jumper at E6 pin 6-7 must be moved back from pins 6-7 to pins 5-6
to re-enable the Power-On and Administrator Passwords.
Writer: Compaq Computer Corporation Project: Using Security Management Comments:
File Name: H-ch6.doc Last Saved On: 4/14/97 11:56 AM