I/O Board Battery Install - Compaq ProSignia 200 Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
A-2 Installing a New Battery

I/O Board Battery Install

To install the new battery, complete the following steps:
!
1. Turn off your server, unplug it, and disconnect any external devices.
2. Remove the server cover. See the instructions in Appendix E,
"Installing the Server," for information on removing the cover.
3. Plug the battery connector onto pins 9-12 at E9 on the system board.
Figure A-1. Connecting and installing the battery on the chassis
Writer: COMPAQ Project: Installing a New Battery Comments:
WARNING:
The system board contains a clock/CMOS lithium battery.
The lithium battery may explode if mistreated. The battery is soldered in
place and may not be removed. Do not abuse or disassemble. Use only
replacement batteries supplied by Compaq Computer Corporation (spare
part number 160274-001).
File Name: K-appa.doc Last Saved On: 4/14/97 1:43 PM