Accessing The System Configuration Utility; Power-On Password - Compaq ProSignia 200 Manual

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessing the System
Configuration Utility
Most of the security features are established through the System Configuration
Utility. To access this utility, complete the following steps:
1. Turn on the server to start the boot sequence.
2. Press F10 when the following message appears at the top of the screen
during POST:
Press "F10" for System Partition Utilities
If you do not press F10 during this time, you must reboot the server to run the
System Configuration Utility.
3. Select System Configuration from the main menu and press Enter.
4. Select Configure Hardware and press Enter. (There will be some delay
at this point while the server loads the configuration files.)
5. Select Step 3: View or Edit Details and press Enter.
6. Use the arrow keys to select the feature you want and press Enter.
7. Use the arrow keys to enable the feature as shown:
( ) Disabled
( • ) Enabled
8. Save the configuration and exit the utility.

Power-On Password

The Power-On Password prevents use of the computer unless the correct
password is entered when the server is turned on.
When you turn on the server, a Power-On Password screen appears. You must
enter the valid password before you can continue the boot sequence.
Writer: Compaq Computer Corporation Project: Using Security Management Comments:
File Name: H-ch6.doc Last Saved On: 4/14/97 11:56 AM
Compaq ProSignia 200 Server Reference Guide
6-3