Compaq ProSignia 200 Manual page 150

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DAAD Diagnostic Messages
Message
Accelerator parity
write errors: n
Accelerator status:
Permanently
disabled
Accelerator status:
Possible data loss in
cache
Accelerator status:
Temporarily
disabled
Accelerator status:
Unrecognized status
Writer: Compaq Computer Corporation Project: Diagnostics Tools Comments:
continued
Description
Number of times that If there are many parity errors, you may need to
write memory parity replace the array accelerator board.
errors were detected
during transfers to
memory on the array
accelerator board.
Array accelerator board Check the Disable Code field. Run the System
has been permanently Configuration Utility to reinitialize the array
disabled. It will remain accelerator board.
disabled until it is
reinitialized using the
System Configuration
Utility.
Possible data loss There is no way to determine if dirty or bad data
detected during power- was in the cache and is now lost.
up due to all batteries
being below sufficient
voltage level and no
presence of the
identification signatures
on the array accelerator
board.
Array accelerator board Check the Disable Code field.
has been temporarily
disabled.
A status returned from Call your Authorized Compaq Reseller for the
the array accelerator latest copy of DAAD.
board that DAAD does
not recognize.
File Name: J-ch8.doc Last Saved On: 4/14/97 12:05 PM
Recommended Action
continued
Compaq ProSignia 200 Server Reference Guide
8-37