Compaq ProSignia 200 Manual page 40

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
You may also run Compaq Utilities remotely over an IPX or IP network using
the Network feature:
To use Compaq Utilities on an IPX network, you must have Compaq
Insight Manager 2.0 or later or an NVT (Novell Virtual Terminal)
Terminal Emulator with VT100 or ANSI terminal capabilities.
To use Compaq Utilities on an IP network, you must have Insight
Manager 2.10 or later or a Telnet Terminal Emulator with VT100 or
ANSI capabilities.
If you are notified that ASR-2 restarted the server and you have restarted to
Compaq Utilities, use the Inspect Utility or Insight Manager to view the
critical error in the Critical Error Log. Run Diagnostics to diagnose and
resolve the problem.
You can configure ASR-2 to restart the server into Compaq Utilities to
diagnose the critical error, or to start the operating system to return the server
to operational status as rapidly as possible.
When you enable ASR-2 to start the operating system, the server tries to start
from the primary partition. In this mode, ASR-2 can page you if a critical error
occurs, but you cannot access Compaq Utilities.
When you enable ASR-2 to start Compaq Utilities, your server restarts after a
critical error and loads Compaq Utilities from the system partition on the
hard drive.
You can configure your server to start Compaq Utilities in four different ways:
Without remote console support; for example, to run Compaq Utilities
from the server console only
With remote console support using modems for dial-in access
With remote console support using a modem to dial a predetermined
telephone number
With remote console support through a network connection
(IP or IPX)
Writer: Compaq Computer Corporation Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/14/97 11:14 AM
Compaq ProSignia 200 Server Reference Guide
2-13