Compaq ProSignia 200 Manual page 47

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-20 Server Management
Pager Settings for Booting into Compaq Utilities
Option
Network
frame type
Network IP
address
Network IP
net mask
Network IP
router
address
If you configure the server to boot into Compaq Utilities, the server prepares
for remote communications, so you can remotely run Diagnostics software,
Inspect Utility, or System Configuration Utility using a workstation running
terminal emulation software, such as Insight Manager or PC Anywhere.
Writer: Compaq Computer Corporation Project: Server Management Comments:
Setting
ETHERNET_II
File Name: D-ch2.doc Last Saved On: 4/14/97 11:14 AM
continued
Description
Select the frame type for your network. Selections
include both Ethernet and Token Ring topologies.
Enter the IP address for this server in standard dot
notation.
NOTE: This is not used if you select Custom for
Network controller. You must enter your IP
address in the NET.CFG file that you load into the
system partition.
Enter the net mask for this server in standard dot
notation.
NOTE: This is not used if you select Custom for
network controller. You must enter your IP address
in the NET.CFG file that you load into the system
partition.
Enter the router to be used for this server in
standard dot notation.
NOTE: This is not used if you select Custom for
network controller. You must enter your IP address
in the NET.CFG file that you load into the system
partition.