Pci Performance Graphics Controller Memory Module Upgrade - Compaq DESKPRO 2000 SERIES Maintenance & Service Manual

5.1.10.4 PCI Performance Graphics Controller Memory Module Upgrade

To install a graphics memory module upgrade for the Cirrus Logic Performance graphics controller
that is preinstalled in the system board, complete the following steps:
1. Perform preparation procedures described in Section 5.1.3.
2. Remove the system unit cover (Section 5.1.6).
3. Remove any outboard expansion boards that might block access to the controller slot (Section
5.1.8).
4. Install the graphics upgrade module onto the system board.
Figure 5-23. Installing a 1-MB EDO DRAM Module onto the System Board
5. Replace the system unit cover.
6. Turn the computer on and start the Windows program.
7. Select the Display icon in the Compaq Utilities group box in Windows NT 3.51 or Windows 3.1, or
the Display icon in Windows 95, to take advantage of the additional display modes now available
with the upgraded memory. Follow the instructions on the screen.
8. Test the system (optional) using the Computer Checkup (TEST) utility. Refer to Chapter 2,
"Troubleshooting."
Compaq Deskpro 2000 5-27