Compaq ProSignia 200 Manual page 9

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
xii Introduction
Chapter 8 − − Using Diagnostics Tools
This chapter describes software and firmware diagnostic tools available
for ProSignia 200 users.
Appendix A − − Installing a New Battery
This section contains information on replacing the I/O and riser card
controller batteries.
Appendix B − − Power Cord Set Requirements
This appendix contains requirements for the power cord set now
available with the ProSignia 200 servers. A table lists power cord set
requirements for each country.
Appendix C − − Electrostatic Discharge
This section suggests ways to prevent electrostatic discharge (ESD) and
the damage it can cause.
Appendix D − − Switches and Jumpers
This appendix provides the correct settings for the switches on the I/O
board and riser boards.
Appendix E − − Installing the Server
This appendix provides instructions for first-time server installation.
Appendix F − − Federal Communications Commission Notice
This appendix includes regulatory notices required by various agencies.
Index
Writer: Compaq Computer Corporation Project: Introduction Comments:
File Name: B-intro.doc Last Saved On: 4/14/97 1:34 PM