Compaq ProSignia 200 Manual page 62

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-8. Removing the system board tray
To remove the system board tray, follow these steps:
1. Shut down all programs and the operating system.
2. Turn off the server and any external devices.
3. Disconnect the power cord from the power outlet.
4. Remove the side access panel.
5. Remove the expansion backplane brace as described in the previous
section, "Removing the Expansion Backplane Brace."
6. Disconnect the power supply and drive signal cables from the
system board.
7. Grasp the back edge of the system board tray and slide it out of
the chassis.
Writer: Compaq Computer Corporation Project: Installing Hardware Options Comments:
CAUTION:
Before removing the side access panel, be sure that the
server is turned off and that the power cord is disconnected from the
electrical outlet.
File Name: E-ch3.doc Last Saved On: 4/14/97 11:21 AM
Compaq ProSignia 200 Server Reference Guide
3-11