Compaq ProSignia 200 Manual page 44

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pager Data
Pager status
Pager dial
string
Pager
message
Pager test
Writer: Compaq Computer Corporation Project: Server Management Comments:
Table 2- 3
Compaq System Configuration Utility
Pager Settings for Booting into Compaq Utilities
Setting
Enabled Indicates if the pager feature is enabled or disabled.
ATDT 555- Indicates the pager dial string and delay before the
5555 pager message. Pagers typically use one of the following
formats:
Local pagers: ATDT 555-5555,,
Wide area pagers: ATDT 1-800-555-5555,,,,,1234567#
1234567# Represents a unique number (maximum seven digits,
numeric only) that you must designate to identify the
server on your pager display. The ROM adds a three-
digit code to the front of this number. The first two
indicate the subsystem and the third indicates the
severity of the error that caused the alert. The # symbol
usually terminates the message. If no message is
required, delete the # symbol.
Select to Use this to test the current pager settings. Press Enter
test to dial the pager number, and the pager message (if
pager present) displays. You must configure the computer
setup before testing the pager and the Pager Status must be
set to Enabled. Do not test the pager if you are running
remotely and are using only one modem.
File Name: D-ch2.doc Last Saved On: 4/14/97 11:14 AM
Description
continued
Compaq ProSignia 200 Server Reference Guide
2-17