Reusing The Device After A Period Out Of Use - Smeg BPW1260 User Manual

Flushing of the detergent system is vital to prevent the chemicals from crystallising and
possibly damaging the dispensing system.
14.4

REUSING THE DEVICE AFTER A PERIOD OUT OF USE

If the device has not been used for a long time, proceed as follows before running a cycle.
•
Inspect the filters at the inlets of the water hoses and check that no sludge or rust has deposited in the
pipes; if this has occurred, allow water to run from the water supply tap for a few minutes.
•
Restore the power supply (if disconnected).
•
Reconnect the water supply hoses and turn the taps back on.
•
Check that the Date and Time are set correctly.
•
If the detergent system has been flushed, proceed as follows:
•
Return the detergent intake nozzles to the jerry cans of the relative products, taking care to put the
right nozzle in each can.
•
When restarted, the device prompts the user to perform an automatic washing and thermal
disinfection cycle. Confirm with the "confirm" button (P5).
Confirming performance of a thermal disinfection cycle with no load before using the device is
highly recommended if it has been out of use for 24 hours or more.
User Manual 193909105 rev.02 BPW1260 Page 80 – 93