If The Glassware Washer Is Not Used For A Long Period Of Time; Reusing The Glassware Washer After A Long Standstill Period; Troubleshooting - Smeg GW2045 Operating Instructions Manual

9.2. IF THE GLASSWARE WASHER IS NOT USED FOR A LONG PERIOD OF TIME

Carry out the soaking programme twice consecutively.
•
Detach the plug from the socket/cut off electricity supply from the appliance.
•
Leave the door slightly open to prevent unpleasant odours from forming inside the washing chamber.
•
Shut off the water cock.
•

9.3. REUSING THE GLASSWARE WASHER AFTER A LONG STANDSTILL PERIOD

Check that there is no sludge or rust in the pipes. In this case run water from tap for a few minutes.
•
Reattach electricity supply plug.
•
Reattach the flexible water supply pipe and open tap.
•

9.4. TROUBLESHOOTING

Slight faults can sometimes be eliminated by the user with the aid of the following instructions.
1. If the programme fails to start, make sure that:
the glassware washer is connected to the electricity main;
•
the glassware washer is being powered;
•
the water cock is open;
•
the door of the glassware washer has been closed properly.
•
2. If water stagnates in the glassware washer, make sure that:
that the outlet hose is not pinched
•
the drain trap is not clogged;
•
the filters of the glassware washer are not clogged.
•
3. If the instruments are not cleaned properly, make sure that:
an adequate amount of detergent has been added;
•
there is regenerating salt in the relative reservoir;
•
the instruments have been positioned correctly;
•
the programme is suitable for the type and degree of dirt on the instruments;
•
all the filters are clean and correctly seated;
•
the holes in the water spray arms are not clogged;
•
nothing is preventing the spray arms from turning.
•
4. If the instruments fail to dry or remain opaque, make sure that:
there is neutralizing agent in the relative container;
•
the neutralizing agent dispenser has been regulated in the correct way;
•
the detergent used is of good quality and has not lost its characteristics (e.g. owing to incorrect storage,
•
pack left open, etc.).
5. If the instruments are streaked, stained... make sure that:
the amount of neutralizing agent dispensed is not excessive.
•
6. If there are visible traces of rust in the washing chamber
The washing chamber is made of corrosion-proof steel, thus rust stains are due to external factors
•
(pieces of rust from the water pipes, etc.). Specific products are available in the shops to eliminate these
stains..
Make sure that the detergent dosage is correct. Some detergents can be more corrosive than others.
•
Check that the salt tank top is closed correctly and the water softener system has been adjusted
•
correctly.
Contact your nearest authorized technical assistance center if the faults persist after compliance with the
instructions given above.
.
Rev. 00
GW2045 – GW1060 Manual Pag. 41 di 43