If The Device Is To Be Out Of Use; Reusing The Device After A Period Out Of Use; Troubleshooting - Smeg Tethys D60 User Manual

9.3

IF THE DEVICE IS TO BE OUT OF USE

If the appliance is to be left unused for a long time, follow these recommendations.
The procedure is recommended for periods of 24 hours or more out of use.

Perform the PREWASH program with the appliance empty.

If contaminated materials are processed: run program 15 (or a program with a thermal disinfection Td phase)
with no load in the appliance.

Disconnect the electricity supply.

Leave the door slightly open to prevent unpleasant odours from forming inside the washing chamber.

Turn off the water intake tap.
9.4

REUSING THE DEVICE AFTER A PERIOD OUT OF USE

If the appliance has been unused for a long time, before starting a cycle, follow these recommendations.

Inspect the filters at the ends of the water intake hoses and check that no sludge or rust has deposited in the
pipelines; if this has occurred, allow water to run from the water supply tap for a few minutes.

Restore the electricity supply (if disconnected).

Reconnect the water supply hose and turn on the tap.

Run PROGRAM 15 (or another program with a thermal disinfection Td phase) with no load for processing.
A thermal disinfection cycle should be performed before using the device if it has been out of use
for 24 hours or more.
WARNING: after 24 hours of inactivity, the device automatically proposes a self-disinfection cycle
93°C. The display shows "PdIs". It is advisable to run the program without load, no load inside the
washing chamber.
Press the "Start / Stop" button to start the program.
Press the Cycle Selection buttons, "Left selection" or "Right selection" to ignore the suggestion.
9.5

TROUBLESHOOTING

Slight faults can sometimes be eliminated by the user with the aid of the following instructions.
1. If the programme fails to start, make sure that:

The appliance is connected to the electrical mains.

The appliance is receiving power.

The water tap is turned on.

The door of the appliance has been closed properly.
2. If water stagnates in the device, make sure that:

There are no tight bends in the drain hose.

The drain trap is not clogged.
User Manual
fig. 40 – Self-disinfection Cycle "PdiS".
Tethys D60 - Tethys T60 - Tethys T45 Page 62 - 77