Smeg BPW1260 User Manual page 39

WARNING
Once a product has run out, replace the empty jerry can with a full can of the same product.
1 - Put the new jerry can in position and fully insert the intake nozzle.
2 - Fit the rubber cap over the top of the can for a perfect, secure connection.
3 - The device automatically recognises the full jerry can and cancels any low chemical level alerts.
The label on the suction hose must correspond to the type of detergent being used. Refer to the
following colour code:
1. White/clear: P1, alkaline detergent
2. Red: P2, acid descaler
Connection errors reduce the effectiveness of the process and may damage parts of the circuit.
Chemical suction system connection errors lead to the loss of Warranty cover for the parts
concerned.
The suction pipe is complete with an intake filter. Make sure the filter is always present and
properly located to ensure that the detergent intake system can operate properly. Check
regularly that the silicone hose is properly secured to the suction pipe and that there are no leaks.
Jerry cans must be securely positioned inside the bottom compartment with the intake nozzles inserted.
Example of position of jerry cans inside bottom compartment
User Manual 193909105 rev.02 BPW1260 Page 39 – 93