Table of Contents
Advertisement
10.11
EDITING CUSTOM PROGRAMS
Warning: construction of a custom washing program requires specific knowledge both of the
load treatment process and of the parameters of the device being used.
A program can only be edited using the external app supplied by the Manufacturer and only
by the person responsible for the device within the facility (the"Superuser").
Always proceed in compliance with the regulations in force in the place of installation: a custom program
used for processing the load must be validated by the user in accordance with the relevant regulations and
standards.
Programs which can be edited:
1. are identified as "custom" programs;
2. form part of the set of programs installed;
3. appear at the end of the list of non-editable factory-set programs;
As envisaged by the reference standards [EN ISO 15883-1], if a process parameter is modified, specific
performance qualification procedures must be repeated.
Consult the authorised after-sales service for further information.
User Manual
193909105 rev.02
BPW1260
Page 64 – 93
Advertisement
Table of Contents
