Related Manuals for Smeg B9040L
Summary of Contents for Smeg B9040L
- Page 1 B6040L – B9040L MANUAL FOR INSTALLING INSTRUMENT WASHERS ON THE RELATIVE STAND USER MANUAL TRANSLATION OF THE ORIGINAL INSTRUCTIONS...
- Page 2 Using the device in any manner other than that specified by the manufacturer may void the warranty. In case of repairs or replacements, only use genuine Smeg spare parts. The information in this manual is provided for guidance only. The contents and the equipment described may be subject to change without notice.
-
Page 3: Table Of Contents
Technical Characteristics ........................... 4 ACCESSORY - DEVICE COMPATIBILITY ........................6 B6040L – STAND FOR DEVICES WIDTH 60 CM ....................6 B9040L – STAND FOR DEVICES WIDTH 90 CM ....................6 INSTALLATION ................................7 Preliminary operations ............................7 Placing the device on the stand........................8 Fixing. -
Page 4: General Notes
Technical Characteristics SMEG has produced these stands which allow the appliance’s loading level to be raised to a convenient height of about 70 centimetres above the ground, and which also provide useful space in the integral cupboard with lock and key. - Page 5 Accessories included: 4 (four) screws code 89937047200 4 (four) feet code 14890229000 1 shield plate Tools required The screws supplied are size 10 with hexagonal head; use of a socket wrench (or a ratchet wrench (fig.)) is therefore recommended; to adjust the feet, we advise using pipe tongs and a spirit level. Spirit level B6040-B9040 USER MANUAL...
-
Page 6: Accessory - Device Compatibility
WARNING: If the AQUASTOP “AS4060” optional is installed on the device, use of the additional “ASB6040L” kit essential for installation of the stand. 2.2 B9040L – STAND FOR DEVICES WIDTH 90 CM The accessory can be installed on the following devices:... -
Page 7: Installation
3 INSTALLATION Remove the product from the packaging. 3.1 Preliminary operations ILLUSTRATION DESCRIPTION Fitting the feet. Remember that the height of the feet can be adjusted. IMPORTANT level perfectly before placing the device on the stand. If possible, to facilitate subsequent maintenance work, remove the steel base shield for direct access to the technical compartment. -
Page 8: Placing The Device On The Stand
There is no need to remove the feet from the device. Also remember that the device is simply rested on the stand, since there are no interlocking parts. STAND B9040L STAND B6040L Remove the protective films. B6040-B9040 USER MANUAL... -
Page 9: Fixing
Fixing. Once the device has been placed on the stand, they must be fixed together. USING THE HOLES MARKED BY THE CIRCLES. B9040L B6040L Holes in stand to be used. Holes in stand to be used. Fix the stand to the device using three of the four Fix the stand to the device using the four screws in the bag. -
Page 10: Fitting The Shield Plate Underneath The Device
3.4 Fitting the shield plate underneath the device Installation of the shield plate is essential to ensure the safety of the device It ABSOLUTELY ESSENTIAL to install this part with the greatest care! ILLUSTRATION DESCRIPTION Fit the right-hand edge of the top shield, resting it on the upright fix on the left using the screws... -
Page 11: Manufacturer And After-Sales Service Contact Information
• After-Sales Service, Service and Technical Information, contact: Single contact number for Italy +39 0522.160.60.50 Email: assistenza.instruments@smeg.it • For sales information Email: instruments@smeg.it International Customers Please contact your Local Smeg Distributor or write an email to service.instruments@smeg.it B6040-B9040 USER MANUAL...