N.B.: the authorised engineer may set up the device so that the power cable and water
connection hoses are accessible through the rear of the device instead of through the side of
the stand.
7.2
CONNECTING THE DRAIN TRAP
Each device comes complete with a PE drain trap Ø110 mm to drain the washing water from each phase and
the water left in the device at the end of the thermal disinfection cycle. The drain trap is connected to the
chamber collar by means of a steel screw tie with seal, and the overflow hose from the accumulator tank is
fixed to it.
CHAMBER
DRAIN
TRAP
Ø110 MM
User Manual
193909105 rev.02
SCREW TIE FITTING
TANK
DRAIN PIPE
BPW1260
OVERFLOW
Page 35 – 93