Smeg BPW1260 User Manual page 26

USE OF AND ACCESS TO THE DEVICE
The device must only be used by staff suitably trained in its operation.
REPORTING SERIOUS INCIDENTS
The person responsible for the device is obliged to report any serious incident occurring in
relation to it to the manufacturer.
The authorised after-sales service will interface with the headquarters after-sales service for
information and for timely management of the event.
The incident must also be reported to the competent authorities of the member state in which
the device and user are located.
See Regulation 2017/745 for the definition of "serious incident".
[Information provided in compliance with requirement 23.4 of the MDR]
RECOMMENDED DETERGENTS AND CHEMICALS
The device's performance and safety have been tested with reference to the chemical products
recommended by the Manufacturer.
As well as performance tests, specific tests relating to safety aspects have also been conducted:
1. On process residues on the processed load, including toxicological checks;
2. On the emission of substances into the working environment where the device is
installed.
Use of the device in combination with chemicals other than those recommended by the
manufacturer may cause a deterioration of its performance and lead to problems regarding the
safety of the device, its operators and the environment.
WATER SUPPLY CONNECTIONS
Hot and cold water supply connections are necessary for installation of the device.
If hot water is not available, the user is responsible for checking that the device's performance is
adequate for their specific conditions of use.
FLAMMABLE SUBSTANCES
Do not place flammable substances inside the device. Do not use flammable detergents.
Do not place alcohol or solvents such as turpentine, which might cause an explosion, inside the
device. Do not place materials dirty with ash, wax or paint inside the device.
WARNINGS REGARDING SAFE DISPOSAL OF THE DEVICE AT END-OF-LIFE
At end-of-life the device may be contaminated (e.g. organic material may be present, especially if the
device has ended its working life due to a fault that has caused the failure of the last thermal disinfection
cycle): take appropriate care during decommissioning procedures, complying with the precautions set out
in the "PRECAUTIONS FOR ACCESSING AND REUSING THE DEVICE AFTER AN INCOMPLETE CYCLE AND FOR
ACCESS TO THE DEVICE AT END-OF-LIFE" section
Once decommissioned, the device must be rendered unusable. Cut the power supply cable after removing
the plug / disconnecting the cable from the power socket.
User Manual 193909105 rev.02 BPW1260 Page 26 – 93