Make sure that the water inlet and discharge water onto it! There is the risk of electric shock! folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures.
To prevent such situations and to ensure smooth water intake and discharge of the machine, fix the end of the stopper group.) discharge hose tightly so that it cannot come out.
To prepare the product for washing laundry, perform product may move from its place and cause Additional Water or Extra Rinse auxiliary functions with a clean piece of cloth after the programme has come to an end. 2. Adjust the feet until the product stands level and machines.
Refer to your local dealer or solid waste collection centre in your area to learn how to dispose of your product. reduce pilling. the locking mechanism of the loading door so flour, lime dust, milk powder, etc.
Page 6
- (II) for main wash – (III) for softener Pour the softener into the softener compartment of – (*) in addition, there is siphon piece in the softener the detergent drawer. compartment. Use the dosages recommended on the package.
Page 7
Using starch into the softener compartment as instructed on the package. washing cycle. clean cloth after using starch. Using bleaches prewash compartment. As an alternative...
4 Operating the product Control panel Display symbols Preparing the machine Make sure that the hoses are connected tightly. Plug in your machine. Turn the tap on completely. Place the laundry in the machine. Add detergent and Programme selection in accordance with the "Programme and...
Programme duration may automatically washing detergent. if you wash less amount (e.g. ½ capacity or less) of Special programmes For specific applications, select any of the following programmes.
No Spin function with the help Temperature selection Whenever a new programme is selected, the maximum temperature for the selected programme appears on the temperature indicator. To decrease the temperature, press the on the display. recommended temperature for the selected programme appears on the display.
Page 12
* : Automatically selected, no canceling. ** : Energy Label programme (EN 60456 Ed.3) *** : If maximum spin speed of the machine is lower then this value, you can only select up to the maximum spin speed. - : See the programme description for maximum load.
F4 appears on the display when you select this function. immediately after the programme completes, you “:” sign in the middle of the delayed start time on the may use rinse hold function to keep your laundry display starts flashing.
Press and hold 2 and 4 Loading door lock There is a locking system on the loading door of the new programme. machine that prevents opening of the door in cases Canceling the programme at which the programme was cancelled remains lit.
Programme avoid touching of the residues in the drawer with and discharge the water in the machine. into its place after cleaning and make sure that it is Machine is in Rinse Hold mode seated well.
Page 16
Pull the emergency draining hose out from its seat to drain the water in the machine completely. When plug again and fix the hose in its place. Turn the pump filter to take it out. have an emergency draining hose: Place a large container in front of the filter to (anticlockwise) until water starts to flow.
Page 17
Figures in this manual are schematic and may not match the product exactly. Values stated on the product labels or in the documentation accompanying it are obtained in laboratory conditions in accordance with the relevant standards. Depending on operational and environmental conditions of the product, these values may vary.
Timer indicator will not countdown until the machine takes in adequate amount of water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack of water. Timer indicator will resume countdown after this.