Fixing To The Floor - Smeg BPW1260 User Manual

6.1.2 FIXING TO THE FLOOR

4 anchor bolts diameter 8mm can be used to fix the stand to the floor, fitting the screws in the 4 points shown
below. Once the "L" brackets have been fixed to the floor, secure them with the four retainer screws.
Place the pallet next to the front of the stand and, making sure you have removed the screws which fix the
device to the pallet, slide the device onto the edge of the stand until the two rear edges are aligned.
Finally, fix the device to the stand with the 4 M8 screws provided (two per side) and the 2 M4 screws for the
front (open the door of the bottom compartment to insert the last two.).
User Manual 193909105 rev.02 BPW1260 Page 32 – 93