Table of Contents
Advertisement
The value can be reset by a Smeg authorised
engineer: hold down P5.
The initial value of RM-90 is restored and the
countdown restarts.
10.10
MEMORY AND PRINTOUT
Terms and abbreviations used and their meanings
CW
HW
CW+HW
L
PREWASH,
WASH,
THERMAL
DISINFECTION,
RINSE,
COOLING
(FAN-ASSISTED
OR
NATURAL)
U.B., B.P. 1, ALL
P1, P2...
Heating ON
Min-Max
Notes for correct understanding of the program record
Each phase:
- starts by loading a certain amount of water, indicated in the record since it is characterised by the type and
amount of water loaded;
- terminates by completely emptying out the water from the chamber. This is not recorded as an event in the
program record.
The following is an example of a program record.
User Manual
Cold water. Example: "Load CW / 23L" means: load cold water, 23 litres.
Hot water
Cold water and hot water
Litres – The amount of water loaded during a phase.
Descriptions of the various types of phases available.
Solenoid valves active in the specific washing phase
The codes indicate the dispensing of chemical products by peristaltic pump P1, P2
...
E.g.: "P1 = 117 ml" – amount dispensed by peristaltic pump P1.
Identifies the initial instants when the heating elements are turned on. Not all
activations are recorded; only those which mark the start of heating.
At the end of the holding time, the min/max temperatures of the holding time are
recorded.
193909105 rev.02
BPW1260
Page 62 – 93
Advertisement
Table of Contents
