Table of Contents
Advertisement
7 CONNECTING TO THE ELECTRICITY AND WATER SYSTEMS
In the standard factory setup the power supply cable and the water intake hoses are accessible from low
down on the back of the device.
7.1
ACCESS TO CONNECTIONS
During transportation, the hoses and cables are safely positioned secured with ties to the rear cross-piece
underneath the rear panel.
During initial installation, the authorised engineer will access the connections by:
1. Removing the ties.
2. Positioning the hoses correctly:
a. Red hose: hot water;
b. Blue hose: cold water.
3. Positioning the power supply cable correctly.
The stand has pre-cut holes for the intake hoses and power supply cable to pass through at the side.
Description
of
fundamental steps
Detail of the pre-cut hole low
down to take the water intake
hoses and power supply cable.
Remove the pre-cut metal
from the hole and then: use
the rubber guard on the metal
edge to protect the hoses
from the risk of cutting.
The hoses and cables must be
positioned correctly, using the
rubber guard on the sharp
metal edges.
N.B.: although the connections can be passed through either side of the stand, the ideal
solution for correct installation is with the water intake hoses coming out of the left-hand
side of the stand and the power supply cable from the right-hand side.
This situation is illustrated below.
User Manual
the
193909105 rev.02
Illustrations
BPW1260
Page 34 – 93
Advertisement
Table of Contents
