If The Device Is To Be Out Of Use; Reusing The Device After A Period Out Of Use; Troubleshooting - Smeg WD2145 User Manual

 Without pressing the tabs, lift the entire unit (D).
When cleaning this filter, it is best also to clean the others.
9.3

IF THE DEVICE IS TO BE OUT OF USE

If the appliance is to be left unused for a long time, follow these recommendations.
The procedure is recommended for periods of 24 hours or more out of use.

Perform the PREWASH program with the appliance empty.

If contaminated materials are processed: run program 15 (or a program with a thermal disinfection Td phase)
with no load in the appliance.

Disconnect the electricity supply.

Leave the door slightly open to prevent unpleasant odours from forming inside the washing chamber.

Turn off the water intake tap.
9.4

REUSING THE DEVICE AFTER A PERIOD OUT OF USE

If the appliance has been unused for a long time, before starting a cycle, follow these recommendations.

Inspect the filters at the ends of the water intake hoses and check that no sludge or rust has deposited in the
pipelines; if this has occurred, allow water to run from the water supply tap for a few minutes.

Restore the electricity supply (if disconnected).

Reconnect the water supply hose and turn on the tap.

Run a program containing a Td thermal disinfection phase, with no load for processing.
A thermal disinfection cycle should be performed before using the device if it has been out of use for 24
hours or more.
WARNING: after 24 hours of inactivity, the device automatically proposes a self-disinfection cycle 93°C. The
display shows "PdIs". It is advisable to run the program without load, no load inside the washing chamber.
Press the "Start / Stop" button to start the program.
Press the Cycle Selection buttons, "Left selection" or "Right selection" to ignore the suggestion.
9.5

TROUBLESHOOTING

Slight faults can sometimes be eliminated by the user with the aid of the following instructions.
1. If the programme fails to start, make sure that:

The appliance is connected to the electrical mains.

The appliance is receiving power.

The water tap is turned on.

The door of the appliance has been closed properly.
User Manual
fig. 46 – Self-disinfection Cycle "PdiS"."
WD2145-WD1160-WD4060-WD4190 Page 67 - 85