Access Manager Configuration - SMC Networks ELITECONNECT SMC2502W User Manual

This command enables and disables L2TP.
set tunnelip dhcp | (range [ip1 ip2])
This command sets the range of IP addresses for PPTP, L2TP, and IPSec
tunnelling.
show pptpl2tp
This command shows PPTP and L2TP settings.
set clientprobes interval timeout
Configures the system to send a probe to clients that are idle for interval
seconds and to disassociate clients that have been idle and not responded to
probes for timeout seconds.
show clientprobes
Display the current configuration of the client probe timers.
set portip port ip-address netmask
Set the IP address and netmask for the specified port.
clear portip port
Clear the IP address and netmask for the specified port.
show portip
Display the current IP address and netmask settings for all ports.
B.8.4

Access Manager Configuration

set bridging on | off
This command enables and disables bridging
add bridging pre-defined-type | quoted custom-bridging-string
This command adds a bridging option.
delete bridging pre-defined type | quoted
custom-bridging-string
This command removes a bridging option.
show bridging
This command shows the current bridging settings.
The current pre-defined bridging types are:
set dhcpserver ip-address
Set the IP address to be used as a DHCP server for client's connected to an
SMC EliteConnect WLAN Security System User Manual
Cisco Discovery Protocol
cdp
Wireless Network Access Protocol
wnmp
IP Multicast
mcast
Type any string
Other
B-9