A General Knowledge Of Vertical System - Owon FDS Series User Manual

8. Horizontal control area:
Contain one key and two knobs.
In the oscilloscope state, the "Horizontal Menu" key corresponds to the
setup menu of the horizontal system, the "Horizontal Displacement" knob
is to control the horizontal displacement triggered, when pressing the knob
horizontal displacement can be zero and the "Gear" knob is used to control
the time base gear.
9. Main menu button: Click to display/hide the main menu, including the
oscilloscope and general function menu list.
10. Oscilloscope function information box: Display horizontal, acquisition, and
trigger information content separately. Click to display/hide corresponding
function setting window.
11. Vertical channel information box: Display the configuration information
content of channel 1 and channel 2 respectively. The information content
includes:channel switch, voltage gear, zero position, bandwidth limit, etc.In
the display content, BW indicates that the bandwidth limit is 20MHz.
The icon indicates the coupling mode of the channel:
" " indicates DC coupling
" " indicates AC coupling
" " indicates ground coupling

A general knowledge of vertical system

As shown in Figure 5-1, there are two buttons and four knobs in the Vertical
Control Area. The following exercises are to guide you through the use of the
vertical settings.
1. Press the Vertical Displacement knob to center display the signal in
the waveform window. It is used to control the vertical display position
of the signal. When turning the Vertical Displacement knob, the
5.Use the Oscilloscope
Figure 5- 1:Vertical Control Area
18