Set The Channel - Owon FDS Series User Manual

6.Use Arbitrary Waveform/Function Generator
generator of the oscilloscope's front panel.
Press the On/Off keys of two channels. To view the output of the signal
generator, connect the other end of BNC cable to the signal input channel of
the oscilloscope's front panel.

Set the channel

 How to switch the channels displayed in the menu
Open the signal source setting window and click CH1, CH2 or CH1/2 at the
upper of the window to switch among Channel 1 menu, Channel 2 menu
and Channel Copy menu.
 How to enable/disable the channel output
Press On/Off key of two channels to enable/disable the output of
corresponding channel. The key light of corresponding channel turns on when
the output is enabled.
 Channel copy menu
Press CH1/CH2 softkey to switch to the Channel Copy menu.
Align Phase
Click Align Phase softkey in the menu below to align the initial phases of two
channel signals.
Copy channel
Select From CH2→CH1 in the menu below to copy the parameters of Channel
2 to Channel 1.
Select From CH1→CH2 in the menu below to copy the parameters of Channel
1 to Channel 2.
Frequency synchronization
Select Frequency Sync as On in the menu below. When adjusting the
frequency of one channel, that of the other changes simultaneously.
Amplitude synchronization
112