How To Conduct Cursor Measurement - Owon FDS Series User Manual

The descriptions of setting menu are shown in the table below:
Menu Setting
Sample
Peak Detect
Mode
Average
1k
10k
Depth 100k
1M
10M
8-bit
Precision 12-bit
14-bit

How to conduct cursor measurement

Press Cursor key or click the main menu window to select Cursor menu
or click Cursor on the function information display bar at the upper part of the
screen, then click the cursor in the function information bar at the lower left of
the screen, the menu is shown in the figure below:
Press Cursor key and the cursor measurement function menu is
displayed on the screen. Then press Cursor key to close the cursor
function menu.
5.Use the Oscilloscope
Descriptions
General Acquisition mode.
Used to detect interference burrs and possibility of
reduce confusion.
Used to reduce random and irrelevant noise in
signal, click
on the right display box.
Click to select the length to be recorded
on the right display box.
Select to set ADC precision.
67
to select the average times