General - Owon FDS Series User Manual

How to quickly output the cloned waveform selected by the cursor line
(1) Click Wave Clone in other modules from the main menu window
the lower right of the screen.
(2) Click Switch to enable it.
(3) Select the cursor line from the Line menu and move to select the
waveform range.
(4) Select the signal source to be output CH1/CH2/NULL from the OSC Menu
on the left of the waveform output (Selecting NULL indicates no output
from this channel).
(5) Select the signal source channel Probe Check from the right AFG menu.
(6) Click Clone in the menu.
For specific operations of the cursor line, refer to "How to conduct cursor
measurement" in Page 52.
Save Cloned Waveform:
(1) Click Wave Clone in other modules from the main menu window
the lower right of the screen.
(2) Click Switch to enable it.
(3) Save the target item to be saved in the Save&Output target menu.
(4) Click Save in the menu or click Rename as required, then input a new
target name on the input soft keyboard and click Save. The target will be
displayed in the target menu with the new name.
Output Cloned Waveform:
(1) Click Wave Clone in other modules from the main menu window
the lower right of the screen.
(2) Click Switch to enable it.
(3) Select the target from the Save&Output target menu.
(4) Click Output in the menu.

General

General module is composed of Network, Default, About, Teaching Model,
Configuration and Hardware Detection.
How to conduct network settings
Conduct the network settings by using LAN interface or Wi-Fi module. If the
LAN interface is used, directly insert the network cable into the LAN interface
5.Use the Oscilloscope
104
on
on
on