Power Output Inspection - Owon FDS Series User Manual

Oscilloscope Inspection
1. Set the Switch in the Oscilloscope Probe as 10X and Connect the
Oscilloscope with CH1 Channel.
Align the slot in the probe with the plug in the CH1 connector BNC, and
then tighten the probe with rotating it to the right side.
Connect the probe tip and the ground clamp to the connector of the
probe compensator.
2. Push the Autoset Button at the top left of the screen or on the front
panel.
The square wave of 1 kHz frequency and 5V peak-peak value will be
displayed in several seconds (see Figure 3- 4).
Check CH2 by repeating Step 2 and Step 3.

Power Output Inspection

Output inspection is to ensure that the instrument can achieve its rated outputs
and properly respond to operation from the front panel.
1. Voltage Output Inspection
(1) When the instrument is under no load, select a channel and ensure the
output current setting for this channel is not at zero.
3.Primary User Guide
Figure 3- 4:Auto set
11