How To Set Xy Mode - Owon FDS Series User Manual

(2) Click Type in the menu to set it as Point or Vector.
(3) Select the duration in the duration display box of the Persist, including
Close, 1 Second, 2 Seconds, 5 Seconds and Infinity. When the
duration is Infinity, the recording point is maintained until the control
value is changed. Select Close to close the afterglow and clear the
display.
(4) Select Clear in the menu to erase previously collected results from the
display, and the oscilloscope will start cumulative collection again.
Color Grade:
The color temperature display function uses the color level to indicate the
frequency of waveform occurrence. Warmer colors such as red/yellow
indicate more frequent waveforms, while cooler colors such as blue/green
indicate less frequent waveforms.
(1) Press Display table button.
Click Color Grade in the menu,when the switch label is highlighted on
(2)
the right, it is enabled,click again to close the Color Grade.

How to set XY mode

After XY mode is selected, both Channel 1 and Channel 2 are opened,
and one waveform amplitude is displayed relative to another. CH1 is
displayed on the horizontal axis and CH2 is displayed on the vertical axis.
The oscilloscope uses the untriggered acquisition mode with the data
displayed as light spot.
Operations of various control buttons are as follows:
 Use Vertical Gear and Vertical Displacement knob of Channel 1 to set
the gear and position in horizontal direction.
 Use Vertical Gear and Vertical Displacement knob of Channel 2 to set
the gear and position in vertical direction.
In the XY mode, the following functions are not available:
 Mathematical operation waveform
 FFT
 DIR
 Pass/Fail
 FRA
5.Use the Oscilloscope
76