How To Conduct System Function Setting; Oscilloscope - Owon FDS Series User Manual

Format the USB disk successfully
8.

How to conduct system function setting

Press Settings key in the front panel oscilloscope area, including two modules:
oscilloscope module and general module function menu window.

Oscilloscope

The oscilloscope module is composed of basic function module, analytical
function module and other modules.
Basic Function Module contains: CH1, CH2, Trigger, Collection and
Horizontal.
For settings of CH1 and CH2 function parameters, refer to "How to set the
vertical system " in Page 28.
For settings of trigger function parameters, refer to "How to set trigger" in
Page35.
For settings of collection function parameters, refer to "How to conduct
collection setting" in Page 66.
For settings of horizontal function parameters, refer to "How to set
horizontal system" in Page 32.
Analytical Function Module contains: Cursor, Measure, Waveform
Calculation, FFT and DIR, FRA, Pass Fail.
5.Use the Oscilloscope
Figure 5- 17:Format process
Figure 5- 18: Format successfully
89