Moving A Single Cartridge - Quantum SuperLoader 3A Series User Manual

Moving a Single
Cartridge
Quantum SuperLoader 3A Series User's Guide
3 From the
Enter
The message
Note: After
LCD, insert the cartridge. After approximately 5 seconds,
the system automatically verifies that a cartridge is
inserted and continues the process. The message
Loaded
Note: For the autoloader, push the cartridge in until it stops. The
cartridge will be about 3 inches (7.5 cm) inside the
mailslot. This may require that you push and have your
fingers well within the mailslot opening. After insertion,
the end of the cartridge will be visible at the back of the
mailslot opening.
4 Once you have inserted the cartridge, press
Note: If the insert cartridge function fails, the cartridge ejects
and you will have to repeat steps
message
5 Press to clear the command and return to the menu.
Exit
You can easily move a single cartridge from one location to another
2
inside the autoloader.
1 From the main menu, scroll to
2 From the
Commands
The screen appears under
Move
the cartridge you want to move. Slots that are occupied by a data
cartridge are indicated by an asterisk (
3 From To:, scroll to the location to which you want to move the
cartridge. Slots that are occupied by a data cartridge are indicated by
an asterisk (
4 Press
Enter
If you select an empty location,
Choose a different location.
submenu, scroll to
Insert Tape, Push Until Prompted
Insert Tape, Push Until Prompted
displays when successfully completed.
displays.
Missed Tape
Commands
submenu, scroll to
From:
). Press .
* Enter
.
No Source Tape
Chapter 2 Operating the Autoloader
Using Cartridges
, and then press
To Location
displays on the LCD.
displays on the
.
Enter
3 and 4 again. The
, and then press
, and then press
Move
. Scroll to the current location of
).
*
appears on the LCD.
.
Enter
Tape
.
Enter
.
Enter
19