Setting The Time; Setting The Time Server - Quantum SuperLoader 3A Series User Manual

Setting the Time

Setting the Time Server

Quantum SuperLoader 3A Series User's Guide
2 From the
Configuration
3 From the
Ethernet
. The cursor automatically displays at the first digit.
Enter
4 At each position of the SNMP server address, use the up and down
arrows to change the value of each digit. Press
cursor to the next digit.
When you have advanced through all of the digits of the SNMP
server address, the autoloader displays
Note: If you make a mistake, press
digit you want to change.
5 Press
Enter
You do not need to reboot the autoloader.
6 Press
Escape
The system time is displayed by On-board Remote Management and it is
2
used internally when logging events and errors. The system time is either
regular time or power-on time. Regular time is Month/Date/Year Time,
such as
Nov/21/2004 19:28
Hours. For example,
number of times the system has booted since it was manufactured, and
POH is the number of hours, minutes, and seconds since the last system
boot. If regular time is known, it will be used, otherwise power-on time is
used.
The SuperLoader 3A Series must be reset after each power up. The time
can be reset automatically if a time server is configured.
If you locate a time server that is compatible with Simple Network Time
2
Protocol (SNTP), you can connect the autoloader to a server that will
supply the correct date and time. The autoloader uses this information to
time stamp information in its memory.
To set a time server address:
1 From the main menu, scroll to
2 From the
Configuration
menu, scroll to
submenu, scroll to
.
New SNMP Server xxx.xxx.xxx.xxx
or to return to the
Enter
. Power-on time is Power On Cycles/Power On
POC: 00121, POH: 00002:07:45
Configuration
menu, scroll to
Chapter 2 Operating the Autoloader
Configuring the Autoloader
, and then press
Ethernet
, and then press
Set SNMP Server
to advance the
Enter
Enter to save.
to backspace to the
Escape
displays on the LCD.
submenu.
Ethernet
where POC is the
, and then press
, and then press
Ethernet
.
Enter
.
Enter
.
Enter
12