Quantum SuperLoader 3A Series User Manual page 89

Quantum SuperLoader 3A Series User's Guide
To perform any of the front panel diagnostic tests:
1 From the main menu, scroll to
2 Scroll to the test that you want to run and press
If you are already logged in as
executing immediately. The message
test is running.
The
Loader—Health Check
indicator while executing. When the test completes, either the
message
Test Successful
error code displays. Proceed to
3 If you are not logged in, you will be asked to enter the
password. Do the following:
a From the front panel, enter the
the and
Up Down
to move to the next digit. To move to the previous digit,
Enter
press
Escape
password, you will be asked to press
submit the password. If the password is incorrect, you will be
asked to re-enter it using the same procedure. Otherwise, you
will be returned to the
desired test.
Running Test
test prematurely, see
b The
Loader—Health Check
indicator while executing. When the test completes, either the
message
Test Successful
an error code display.
4 If the test is successful, press
menu. For detailed results of a test, use On-board Remote
Management to retrieve the diagnostic test status (see
Using On-board Remote
Diagnostic Tests from the Front Panel
Diagnostics
Administrator
Running Test
test displays an ongoing progress
displays or the message
step 4.
Administrator
scroll arrows to select each digit, and then press
. When you have entered the entire six digit
Diagnostics
displays while the test is in progress. To stop the
Stopping a Diagnostic
test displays an ongoing progress
displays or the message
to return to the
Enter
Management).
Chapter 5 Troubleshooting
and press
Enter.
.
Enter
, the test begins
displays while the
Test Failed
Administrator
password by using
one more time to
Enter
menu. Press to run the
Enter
Test.
Test Failed
Diagnostics
Diagnostics
and an
and
test
75