Performing A System Reset; Commands Page; Moving Tapes - Quantum SuperLoader 3A Series User Manual

Performing a System
Reset

Commands Page

Moving Tapes

Quantum SuperLoader 3A Series User's Guide
You will use
System Reset
3
changes, and IP address changes. A system reset will take at least three
minutes if there is a tape in the drive, or approximately 30 seconds
otherwise. To perform a system reset:
1 From any page, click the
displays.
2 Under the
You can move tapes, run a system inventory, or reset the picker to its
home position from the
page displays.
From a remote location, you can request that a tape be moved from one
3
position to another. To move a tape:
1 From any page, click the
displays.
2 From the
Moving Tapes
menu under
want to move.
You can also click the slot on the graphic of the autoloader
Note:
magazine to select and move a cartridge.
3 From the drop-down menu under
you want to move the tape, and then click
Chapter 3 On-board Remote Management
when making mode changes, magazine
Diagnostics
section, click
System Reset
page. When you click
Commands
Commands
section of the page, click the drop-down
and select the current location of the tape that you
From:
Commands Page
heading. The
Diagnostics
.
System Reset
Commands
heading. The
Commands
, select the location to which
To:
.
submit
screen
, the
screen
47