Installing A Blank; Changing The Orientation - Quantum SuperLoader 3A Series User Manual

Installing a Blank

Changing the Orientation

Quantum SuperLoader 3A Series User's Guide
2 Slide the magazine into the magazine bay. Make sure you position
the magazine correctly; it should slide smoothly.
Caution:
3 The magazine is correctly installed when you feel it click into place
and the front is flush with the front panel.
To install a magazine blank:
4
1 Grasp the magazine blank by the handle with one hand and guide
the blank into the magazine bay.
2 Slide the magazine blank into the magazine bay until it stops.
The magazine blank is correctly installed when you feel it
Note:
click into place and the front of the blank is flush with the
front panel of the autoloader.
A magazine or magazine blank can be configured to fit in the right or left
4
magazine bay. The handle must be removed and the appropriate handle
attached to match the orientation of the magazine or blank.
To remove and attach a magazine handle, you will need a #1 Phillips
screwdriver.
Chapter 4 Customer Replaceable Units (CRUs)
Replacing a Magazine or Magazine Blank
Insert the magazine slowly to avoid damaging
internal components or the autoloader.
51