Installing A Magazine; Manually Operating The Magazine - Quantum SuperLoader 3A Series User Manual

Installing a Magazine

Manually Operating the
Magazine
Quantum SuperLoader 3A Series User's Guide
2 Replace the right magazine with a magazine blank.
3 Issue the
Load/Unload
left magazine.
4 If you want to have the magazine in the right-hand bay, replace the
magazine blank in the right-hand bay with a cartridge magazine.
To install a magazine into the autoloader, use the following procedure.
2
1 Grasp the magazine by the handle with one hand and support it
underneath with the other hand.
2 Slide the magazine into the magazine bay until it clicks.
Make sure that you position the magazine correctly. It should slide
into the magazine bay smoothly. If you meet resistance, verify the
orientation of the magazine.
The magazine is correctly installed when you feel it click into place
and the front is flush with the front panel.
Mag Inserted
proceeds to run an inventory.
Caution:
The following section describes how to operate a magazine.
2
There are two knobs located on each end of the magazine. You can move
the slots within the magazine by turning these two knobs and aligning a
slot with one of the two openings. You can use the openings in the
magazine to load and unload cartridges from the eight slots within each
magazine.
Note: It is recommended that you fully remove the magazine to
load and unload cartridges. If the magazine is not fully
removed, do not rotate the magazine.
Using Magazines and Magazine Blanks
command again. The system will then eject the
appears on the LCD. The autoloader automatically
Be careful not to turn the knob on the side of the
magazine while the magazine is partially inserted into
the autoloader. Doing so may cause damage to the
magazine or the autoloader.
Chapter 2 Operating the Autoloader
Left Mag Inserted
or
Right
24