Quantum SuperLoader 3A Series User Manual page 55

Quantum SuperLoader 3A Series User's Guide
4 In the
Username
5 In the field, enter the new password.
Password
6 In the
Verify Password
7 Click .
submit
Note: To view the list of currently defined users, click
with
Select User Type
To set the
Client Authorization Control
1 From any page, click the
screen displays.
2 On the left-hand side of the screen, click
Scroll to
Client Authorization Control
addresses that are authorized to perform functions using On-board
Remote Management for this specific unit. There are two sets of IP
address boxes. You can individually enable/disable and configure
each set.
• If enabled, each set can be used to specify either a range of IP
addresses or a pair of specific IP addresses that are allowed to
administer this unit. A set can also be used to specify a single IP
address if the desired IP address is entered into both the "a" and
"b" portions of the set. When a set is used to specify a range of IP
addresses, the "b" portion of each address set must be greater
than or equal to the "a" portion of that address set.
• If neither set is enabled, any IP client can administer the unit. If a
single set is enabled, only clients that pass the test specified by
that set are allowed administrator access. If both sets are enabled,
any client that passes either of the two filter tests can administer
the unit.
The Web server always allows any client to view the status
information of the unit, regardless of the authorized client list or the
overlap control policy.
3 Use the drop-down box to select
4 Type the IP addresses in the appropriate boxes.
5 Click to save.
submit
Chapter 3 On-board Remote Management
field, enter a user name.
field, re-enter the same new password.
.
:
Configuration
. In this section is a list of the IP
Enable
Configurations Page
submit
heading. The
Configuration
.
Security
or .
Disabled
41