Loader Connector Pin Assignments; Scsi Id; Configuring The Internal Tape Drive For Termpwr; Scsi Connections - Quantum SDLT 600 User Manual

Loader Connector Pin
Assignments
Table 4 8-Pin Loader
Connector Pin Assignments
Signal Name
Ground
REC_FROM_LOADER_H
REC_FROM_LOADER_L
Ground

SCSI ID

Configuring the Internal
Tape Drive for TERMPWR

SCSI Connections

SDLT 600 Product Specification
2
Pin Pin
Number Number
1 5
2 6
3 7
4 8
Each device on the SCSI bus must have a unique SCSI ID address
2
assigned to it. The SCSI ID is set by placing jumpers on the SCSI ID
jumper block at the rear of the tape drive. With no jumpers in place the
tape drive will default to SCSI ID 5 as long as no cable is attached to the
library port. With a library port cable attached the SCSI ID is selected by
the library application.
At least one device on a SCSI bus must supply terminator power
(TERMPWR). TERMPWR is enabled by placing a jumper on the
2
TERMPWR jumper block at the rear of the tape drive. Remove the jumper
to disable TERMPWR.
The various SCSI connector options are:
2
• Multi-mode Single-Ended (MSE) and Single-Ended (SE) Mode
• MSE Low Voltage Differential (MSE LVD) Mode SCSI Connector Pin
Assignments.
Chapter 2 Hardware Specifications
Signal Name
SEND_TO_LOADER_H
SEND_TO_LOADER_L
Ground
LOADER_PRESENT_L
Tape Drive Connections
12