Setting The Scsi Id; Preparing The Host And Verifying The Connection - Quantum SuperLoader 3 Quick Start Manual

SuperLoader™ 3 Quick Start Guide

Setting the SCSI ID

Preparing the Host and Verifying the Connection

16
Each SCSI device attached to a server or workstation must have a unique SCSI ID from 0
through 7. The default SCSI ID is 5 for the SuperLoader 3.
To change the SCSI ID for the SuperLoader 3:
1 If the main menu is not already visible, press
2 On the main menu, scroll to
3 On the submenu, scroll to
Configuration
4 Scroll to the number you want to set as the autoloader's SCSI ID, then press
Cycle Power new SCSI ID
5 Press and hold the power button on the front panel until
appears on the LCD.
appears on the LCD, then the autoloader shuts off.
Power Off
6 Press the power button again to power on the autoloader.
The new SCSI ID is now in effect.
If necessary, install a SCSI, Fibre Channel, or SAS host adapter, software, and compatible
drivers. Refer to the manuals for the host computer and SCSI, Fibre Channel, or SAS host
adapter for detailed instructions. In addition, follow these general guidelines:
• When the host server is powered on, install software, and/or drivers that are
compatible with the autoloader (see
compatibility information is available at www.quantum.com. Most backup software
packages require an additional module to communicate with the autoloader robotics.
• If the host server is connected to a network, check with the system administrator
before turning off power.
• Use proper procedures to prevent electrostatic discharge (ESD). Use wrist-grounding
straps and anti-static mats when handling internal components.
• Make sure that the host server has an open expansion slot.
• Make sure that your backup application supports the SCSI, Fibre Channel, or SAS
host adapter.
• For the SCSI autoloader interface:
• Depending on the server configuration, you may need to change the SCSI ID of
the autoloader (see
Setting the SCSI ID
Enter
and press
Configuration
and press
SCSI ID
appears on the LCD.
Windows Operating System
Setting the SCSI ID).
.
.
Enter
.
Enter
Enter
System Shutdown wait 60 sec
Support). Software
.