Closing The Node Cover - Quantum DXi4700 Upgrade Manual

Figure 22 Installing the H810/
H830 Card in Riser 3

Closing the Node Cover

Installing Components in the Node
H810/H830 card
Expansion card connector
2 Remove the metal slot cover from slot 6 by sliding it out of the slot.
3 Holding the H810 or H830 card by its edges, position the card so that the
connector on the card aligns with the expansion card connector on the riser.
4 Insert the card-edge connector firmly into the expansion card connector
until the card is fully seated.
5 Push the expansion card latch down to lock the H810 or H830 card in place.
To close the DXi4700 Node cover:
1 Lift the latch on the cover (see
Quantum DXi4700 Capacity Upgrade Guide
Expansion card latch (blue)
Metal slot cover
Expansion card riser 3
Figure 23).
6-68107-03 Rev C
December 2016
25