Table of Contents
Advertisement
Opening the
4
Library Door
Closing the
4
Library Door
To open the magazine door, using the OCP:
Press Select until the message EJECT/UNLOCK? is
1
displayed.
Press Next to display the message Eject Cartridge?.
2
Press Next to display the message Unlock Doors?.
3
Press Enter to display the message Are you sure?.
4
Press Enter to remove any cartridge from the drive and
5
display the message Open Doors!.
This activity can take up to three minutes if the cartridge is to
be removed from the drive and the end of data is at the end of
the tape spool. Press any other button to stop the operation.
Open the door using the handle.
6
Note: When the door is unlocked, the message Door
Unlocked! is always displayed. The only way to
restore library operation is to open and close the
library door.
To close the library door, push the door until it latches.
The door automatically locks after approximately five seconds.
The library automatically executes a scan magazine function.
When the scan magazine function is complete, the message
Eject/Unlock? is displayed on the OCP. If the optional bar code
reader is present, the cartridge label bar codes are read.
Quantum|ATL PowerStor L200 Series Library User's Guide
Chapter 4 Using the Library
Using the Library Door
41
Advertisement
Table of Contents
