Table of Contents
Advertisement
SCSI Commands: 22BMODE SELECT
3.10.5.1
Mode Parameter Pages Field Descriptions
Field
Bytes
Bits
Page Code
0
0-5
Additional
1
Page
Length
Mode
2-n
Parameters
Reserved
If the initiator does not set the Additional Page Length field of the Mode Page to the
value indicated in the Mode Page definition (for example, 10h for the Device
Configuration Page), the drive terminates the MODE SELECT command and returns
Check Condition status bytes with an Illegal REQUEST SENSE key. The Additional
Sense Code and Additional Sense Code Qualifier are set to Invalid Field in
Parameter List.
Description
02h = Disconnect/Reconnect Mode Page
0Ah = Control Mode Page
0Fh = Data Compression Control Mode Page
10h = Device Configuration Mode Page
18h = Protocol Specific Logical Unit Mode Page (FC or SAS drives
only)
19h = Protocol Specific Port Mode Page (FC or SAS drives only)
1Ch = Information Exceptions Mode Page
1Dh = Medium Configuration Mode Page
21h = Drive Capabilities Control Mode Page
22h = Interface Control Mode Page
Specifies the length (in bytes) of the Mode Parameters.
The mode parameters are specific to each mode parameter page
and are described in the following sections.
All reserved bits must be o.
Page 83
Advertisement
Table of Contents
