Quantum LTO 3 User Manual page 278

SCSI_FAILED_STATUS_40
SRV_UNTHREAD_RETRY_PIVOT_TRACK_ENGAGE
SRV_THREAD_RETRY_PIVOT_TRACK_ENGAGE
SRV_UNTHREAD_RETRY_PIVOT_TRACK_DISENGAG
E
SRV_THREAD_RETRY_PIVOT_TRACK_DISENGAGE
DSM_CMPR_READ_DP_END_MARK_IN_RECORD
SRV_PARK_CART_EXPECTED_TRAY_OUT
SRV_PARK_CART_FAILED_EJECT
SRV_REEL_CART_HAS_STALLED
SRV_INVALID_CARTRIDGE_RADIUS
SRV_PIVOT_TRACK_RETRY_ENGAGE
SRV_PIVOT_TRACK_ENGAGE_RETRIES_EXHAUSTE
D
SRV_PIVOT_TRACK_RETRY_DISENGAGE
SRV_PIVOT_TRACK_DISENGAGE_RETRIES_EXHAUS
TED
SRV_CART_REEL_OPEN_LOOP_RUNAWAY
SRV_CART_REEL_CLOSED_LOOP_RUNAWAY
SRV_SZA_TZA_INTERFACE_BUSY
SRV_SZA_TZA_FUNCTION_ACTIVE
SRV_SZA_TZA_WRITE_COUNT_TOO_LARGE
SRV_WRITE_SZA_TZA_INVALID_CHIP_ID
SRV_WRITE_SZA_INVALID_ADDR
SRV_WRITE_TZA_INVALID_ADDR
SRV_TX_BUFFER_OVERFLOW
SRV_GOTO_LC_UNEXPECTED_MESSAGE_IN_RAMP_
DOWN_STATE
SRV_ROTATE_UNEXPECTED_MESSAGE_IN_IDLE_ST
ATE
SRV_REEL_ALIGN_SLOT_FAILED_WRITING_TO_LINE
AR_COUNTER_API_BUSY
SRV_REEL_UNEXPECTED_MESSAGE_IN_FINDZERO_
STATE
CALIB_GAIN_DONE_WARNING_HIGH_HEAD_OUTPU
T
CALIB_GAIN_FAILED_LOW_HEAD_OUPUT
CALIB_GAIN_FAILED_HIGH_HEAD_OUPUT
CALIB_GAIN_ERROR_IN_SAMPLE_COUNT
CALIB_GAIN_INVALID_MSG
CALIB_GAIN_UNEXPECTED_SVO_ALERT
CALIB_GAIN_UNEXPECTED_CMD_TYPE
CALIB_GAIN_UNEXPECTED_ZONE_END
CALIB_WI_FILTER_ORDER_TOO_SMALL
CALIB_WI_FILTER_ORDER_TOO_LARGE
CALIB_WI_CURVE_FIT_MAX_TOO_SMALL
CALIB_WI_CURVE_FIT_MIN_TOO_LARGE
CALIB_WI_CURVE_FIT_MAX_LESS_THAN_MIN
CALIB_WI_CURVE_FIT_MIN_POS_LESS_THAN_MAX
CALIB_WI_CURVE_FIT_MID_NOT_FOUND
CALIB_WI_CURVE_FLAT_FROM_AMP
CALIB_WI_CURVE_FLAT_FROM_INDEX
CALIB_WI_CURVE_FIT_SAFE_INDEX_NOT_FOUND
CALIB_WI_UNEXPECTED_CMD_TYPE
CALIB_ILLEGAL_DELILAH_REG
6D9h SCSI SCSI internal status only - not reported
6DAh Servo Exception: Not able to engage Lower Track during Unthread.
Will try again.
6DBh Servo Exception: Not able to engage Lower Track during Thread. Will
try again.
6DCh Servo Exception: Not able to disengage Lower Track during Unthread.
Will try again.
6DDh Servo Exception: Not able to disengage Lower Track during Thread.
Will try again.
6DEh Data set Decompression error - illegal end mark inside record
manager
6DFh Servo
6E0h Servo
6E1h Servo
6E2h Servo
6E3h Servo
6E4h Servo
6E5h Servo
6E6h Servo
6E7h Servo
6E8h Servo Cartridge run away detected during closed loop.
6E9h Servo
6EAh Servo
6EBh Servo
6ECh Servo
6EDh Servo
6EEh Servo
6EFh Servo
6F0h Servo
6F1h Servo
6F2h Servo
6F3h Servo
6F4h Calibration
6F5h Calibration
6F6h Calibration
6F7h Calibration
6F8h Calibration
6F9h Calibration
6FAh Calibration
6FBh Calibration
6FCh Calibration
6FDh Calibration
6FEh Calibration
6FFh Calibration
700h Calibration
701h Calibration
702h Calibration
703h Calibration
704h Calibration
705h Calibration
706h Calibration
707h Calibration Attempt to access a Delilah register not included in the
default.chan register m