Quantum LTO 3 User Manual page 183

SCSI Commands: 40BREQUEST SENSE
Sense
Key ASC ASCQ
Byte 2 Byte 12 Byte 13
03h 30h 00h
03h 30h 02h
03h 30h 07h
03h 30h 0Dh
03h 30h 80h
03h 31h 00h
03h 3Bh 00h
03h 3Bh 08h
03h 50h 00h
03h 50h 01h
03h 51h 00h
03h 52h 00h
03h 53h 00h
03h 53h 01h
04h Hardware Error
04h 40h 80h
04h 40h 81h
04h 40h 82h
04h 40h 83h
04h 40h 84h
Message
Incompatible medium
installed
Cannot read medium
incompatible format
Cleaning failure
WORM medium integrity
check
Firmware tape fail
Medium format corrupted
Sequential positioning
error
Reposition error
Write append error
Write append position
error
Erase failure
Cartridge fault
Media load or eject failed
Unload tape failure
SCSI Task diagnostic
failed
DSM Task diagnostic
failed
ECC Task diagnostic
failed
TAPE Task diagnostic
failed
MIC Task diagnostic failed
Page 175
Explanation
Inserted cartridge is incompatible,
cleaning tape or other.
An operation could not be
completed because the Logical
Format is not correct.
Cleaning tape exhausted, bad, or
attempt to use cleaning tape as a
data tape.
Integrity of WORM medium has
been compromised.
Media error reading firmware tape.
Data could not be read because the
format on tape is not valid, but is a
known format.
A command has failed and left the
logical position at an unexpected
location.
Position lost during Locate or
Reposition command.
A Write type command failed
because the data append point was
unreadable.
Unable to locate the append point
for the write data.
Unable to erase due to media fault.
A command could not be completed
due to a fault in the tape cartridge
An attempt to load or eject the tape
failed due to a problem with the
tape.
Unable to unload tape due to
cartridge or tape problem.
During POST or diagnostics the
SCSI Task reported an error. Refer
to the VSCQ for more information
about the cause.
During POST or diagnostics the
DSM Task reported an error. Refer
to the VSCQ for more information
about the cause.
During POST or diagnostics the
ECC Task reported an error. Refer
to the VSCQ for more information
about the cause.
During POST or diagnostics the
TAPE Task reported an error. Refer
to the VSCQ for more information
about the cause.
During POST or diagnostics the
MIC Task reported an error. Refer
to the VSCQ for more information
about the cause.