Table of Contents
Advertisement
Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Figure 69 SNMP
Community Management
82
8 Under
New Community
A unique name in the
a
(a-z, A-Z), no special characters or blank spaces are allowed
If no communities are defined, the DX-Series system is
Caution:
universally accessible through a "public" community
(read-only).
IP address in the
b
edit box ends in a zero, the value in the IP address edit box must also
end in a zero
Subnet mask in the
c
A single community with an IP address or network mask set to
Note:
or left blank, indicates that IP-address-based access
0.0.0.0,
control is disabled.
Access rights for the new community:
d
•
allows SNMP
Get
•
allows both SNMP
Get/Set
9 Click
.
Add
A
page displays indicating the community has been added.
Results
10 Click Send from the SNMP tab to send a test SNMP trap. Verify that the
SNMP trap was received by the specified destination system.
Configuring the DX-Series System
, enter the new community information:
field, the field holds up to 20 characters
Name
field, if the value in the Network Mask
IP Address
field
Network Mask
operations:
get
and
get
put
operations
Advertisement
Table of Contents
