Quantum DX100 Unpacking And Installation Instructions page 16

Quantum DX-Series System Unpacking and Installation Instructions
Document 6513502-06 A01
October 2006
Figure 9 Installing the
Mounting Spacers
16
Preparing the Storage Array for installation
1 Install a spacer on each side with 6-32 x 10 flat head PHILLIPS screws
provided in the storage array accessory kit (see
Installing the Storage Array
1 Install the left and right storage array support brackets at the beginning of
a hole pattern (see Locating the Mounting Position
loosely install two 10-32 x .50 in. slotted screws on each rail at the front
and back of the rack (see
The support brackets must be installed on the inside rack rails.
Note:
The support brackets extend to accommodate rack depths of 30
Note:
to 36 in. (76.2 to 91 cm).
Installing the DX-Series System
Mounting spacer
figure 10).
figure 9).
on page 12) and
0
0